Lift eFoil drive (community): prop hub dimensions
The fit dimensions PropShaper uses for e-foil and boat propellers on this mount, with the sources behind them. Open it in the studio to design a propeller around this hub and export an STL for printing.
Dimensions
| Shaft bore | ø12.1 mm |
| Cross pin | ø4.2 mm through the hub |
| Hub body | ø55 mm × 35 mm long |
Source quality: Community drawing or measured part; verify before printing.
Fit notes
Lift standard (non-LCS) drive: ø12 shaft (sourced from Lift-compatible aftermarket props) with a shaft cross pin (confirmed by Lift replacement-pin listings). PIN DIAMETER AND HUB ENVELOPE ARE UNVERIFIED placeholders — measure your shaft and pin before printing. LCS props use a different interface. The prop is retained by an M6 centre bolt into the shaft end.
Sources
- EfoilSolutions Lift-compatible prop (ø12 shaft)
- Lift prop shaft pin replacement (pin drive confirmed)
- EfoilSolutions prop remover (M6 centre bolt)
Every dimension stays editable in the studio, so you can adjust the bore or add a set screw to match your own hardware. Printed props are prototypes: check the fit on the bench and spin them up behind a guard.