Minn Kota 1/2″ D-shaft, no pin (MKP-24): prop hub dimensions
The fit dimensions PropShaper uses for e-foil and boat propellers on this mount, with the sources behind them. Open it in the studio to design a propeller around this hub and export an STL for printing.
Dimensions
| Shaft bore | ø12.9 mm, D flat 1.3 mm deep |
| Hub body | ø96.84 mm × 58.74 mm long |
Source quality: Maker spec or retailer listing.
Fit notes
Minn Kota MKP-24 drawing: 1/2″ "D" shaped bore with no drive pin, hub ø96.84 × 58.74, 3/8-24 nyloc nut. The flat depth is not published: measure yours and set the D-flat.
Sources
Every dimension stays editable in the studio, so you can adjust the bore or add a set screw to match your own hardware. Printed props are prototypes: check the fit on the bench and spin them up behind a guard.